Klarstein 10032302 Bedienungsanleitung Seite 25

Lighting
Press the LIGHT button to turn on the light. Press the button again to turn it off again. The
light operates independently of the other functions.
Increase speed
The motor has 3 speed levels: low, medium and high.
• Press the SPEED button 1x to run the motor at low speed.
• Press the SPEED button 2x to run the motor at medium speed.
• Press the SPEED button 3x to run the motor at high speed.
Decrease speed
Each time you press the [-] button, the speed will be decreased to the next level. The
display will show the corresponding speed. If you want to switch off the motor, press the
[-] button until the motor stops.
Set timer
1 Press the TIMER button to activate the timer function. The timer is initially set to 5 minutes.
Each time you press [+], the time will be increased by 1 minute. Each time you press [-],
the time will be reduced by 1 minute. A time of 1-60 minutes may be set.
2 When you have set the timer, press the TIMER button again to confirm or wait 10
seconds for the set time to be automatically applied. The motor will run until the
timer counts down, then it will switch off automatically.
3 If you want to use the set time the next time, just press the TIMER button and then
wait 10 seconds for the last set time to be applied. If you want to enter a different
time, proceed as described in steps 1 and 2. After the timer has been confirmed,
the motor will run until the timer has counted down the time.
Note: If you want to prematurely end an active timer, press the TIMER button again
while the timer is running.
EN
25