MA lighting XL-F Schnellstartanleitung Seite 58

ON / OFF
Connect
Connect the device to the mains. The device adjusts itself automatically (120 -230V / 50–

60Hz).
ixtures, dimmers and so on with a DMX cable
 Connect f
LTC / Audio / Midi etc.
 Connect
xtern monitor to the DVI-D connector (if required).
 Connect e
(dot2 F-wing and/or dot2 B-wing) via Ethernet cable and – if required -
 Connect optional devices
switch.
Switch ON
Set the mains switch on the rear side to „I" position

The device boots short time and is then ready for operation.

NOTE: dot2 F-wing and dot2 B-wing can be operated only connected with a dot2 XL-F, dot2 XL-B
or dot2 core console.
NOTE: NO IP addressing required - IP addressing is done automatically. All connected and
powered devices are represented in the SETUP menu.
Switch OFF
NOTE: Don´t forget to save your show! When the mains switch on the rear side is set to „O",
console will immediately shut down. Any unsaved data will be lost! Since the console of the dot2
family do not have backup batteries, the devices switch off immediately after disconnecting the
power cord. Any unsaved data will be lost also.
Set the mains switch on the rear side to „O" position.

For longer non-use disconnect all cables.

.
(if required).
dot2
Data
Transport
Safety
Instructions
Limitation
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
56