hanseatic HMGS5144A1 Gebrauchsanleitung Seite 43

10. Remove the tapping screw (21), and
screw it back in on the opposite side.
(20)
(19)
11. Reverse the hinge, insert the pin
screw (18) and the snap ring (20)
from the other side, and re-tighten the
nuts (19).
Tip: To tighten the nuts, hold them with the
wrench while tightening the pin screw from
above using the flat-head screwdriver.
12. Position the hinge on the opposite side
on the corresponding holes in the frame,
and re-attach using both screws (16).
(21)
13. Screw both feet (3) back in. Ensure
14. Replace the door on the bottom
(18)
15. Re-attach the top hinge (15) to the
16. Attach the blind covers (11) and (12) and
17. Check to see whether the door seal fits
Start-up
(3)
that the larger of the two screw-in feet
(shown on left) is on the opposite side to
the hinge.
hinge (17).
top of the appliance using the three
screws (14).
(11)
the blind plugs (13) on the door frame.
well (see "Checking and cleaning the
door seals" on page 18).
Page GB-19
(12)
(13)