Harrie Leenders FUGA eL Anleitung Und Montageanleitung Seite 19

General instructions and regulations
• All local regulations including those referring to national and European standards must be observed when installing the appliance.
• Ensure there is sufficient ventilation / air supply in the room from which your stove gets the combustion air.
This is the room where the stove is installed if you do not use a wall or stove-base air-supply system.
• The stove is not suitable for a shared flue system.
• The appliance must be mounted to a wall having sufficient bearing capacity.
• Ensure adequate access for cleaning the appliance, the flue gas connection and the chimney.
• When installing the stove, take into account the minimum distances from the wall so as to avoid any fire risk.
The minimum distances (sizes in cm) are shown in the figure below.
Specifications Fuga eL
• Nominal power of the stove is 8 kWatt.
• Flue gas mass flow = 8,6 g/s
• Appliance weight = 130 kg
• Minimum chimney draught = 8,0 Pa
• Flue gas temperature directly over the stove = 317 °C
34
General instructions and regulations
• The installation of the Fuga eL with decorative casing must be carried out by a skilled person employed by a dealer recognized by Harrie
Leenders Haardkachels.
• The casing parts are susceptible to scratching. Handle them gently.
• After the stove has been properly installed, burn some kindling wood to check the draught.
Safety recommendations
• Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
• For general safety, we refer to guidelines or regulations issued by a relevant official body.
Materials and tools required
• Crosshead screwdriver • Set of masonry bits
• Flathead screwdriver • Knife
• Boxspanner set • Plumb line
• Hexagonal wrench set • Sliding pieces
Materials included
• 4 S6 plugs • 4 self-tapping screws Ø 3.5 x 9.5
• 4 stucco screws (+2 spares)
Note: These installation instructions apply to the stove with either top outlet or rear outlet.
So, as you go along, always ensure you are using the correct instruction.
stove (still
in packaging)
styrofoam
handtruck
1. Moving the stove
• Remove the door and put it in a safe place
• Place styrofoam or a packing cushion between the stove and the
handtruck for protection.
• Move the stove with its front resting against the handtruck.
• Remove the plastic wrapping after positioning the stove.
• Spirit level
• Handtruck
• Single-walled pipe and accessories
(connector)
2a. Installing ceiling or wall plate for stove with top outlet
• Fix the ceiling or wall plate using plugs and chipboard screws.
• Level it (A)
• Determine the centre of the flue on the floor using a plumb line
and mark it off.
35