2 Notes on the documentation
2
Notes on the documentation
2.1
Observing other applicable documents
▶
You must observe all the operating and installation in-
structions included with the system components.
2.2
Storing documents
▶
Pass these instructions and all other applicable docu-
ments on to the system operator.
2.3
Validity of the instructions
These instructions apply only to:
–
Anti-legionella set: 302076
3
Product description
3.1
Design of the product
8
7
6
1
Flat O-seals
2
Pipe connection,
1200 mm
3
M36 x 1.5 union nut
4
Cutting ring
5
O-ring
4
1
2
3
4
5
6
Crosspiece with non-
return valve (cold water
connection)
7
Circulation pump
8
Crosspiece with stop-
cock (domestic hot wa-
ter connection)
3.2
Function
To prevent legionella formation, the cylinder water temperat-
ure must be heated to above 60 °C in the entire area of the
cylinder at regular intervals. The anti-legionella set guaran-
tees that the cylinder water temperature is heated to above
60 °C by the post-heating depending on the anti-legionella
operating time that is set on the system control. The circula-
tion pump feeds the hot cylinder water from the domestic hot
water connection via the bypass to the cold water connection
and into the lower section of the cylinder so that the lower
section of the cylinder is also heated to above 60 °C.
3.3
CE label
The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
4
Set-up
4.1
Checking the scope of delivery
▶
Check that the scope of delivery is complete and intact.
Number
Description
1
Crosspiece with stopcock
1
M36 x 1.5 union nut
2
Flat O-seals
1
Pipe connection, 1200 mm
1
O-ring
1
Crosspiece with non-return valve
1
Cutting ring
4.2
Dimensions
Installation instructions 302076 0020230766_00