Herunterladen Inhalt Inhalt Diese Seite drucken

Scooter Clean And Storage; Clean - Explorer kallio 2 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Clean the Scooter
Clean of the scooter in proper and sui-
table way will make it attractive, extend
it's lfe and optimize the performance.
Before cleaning
1. Cover the muffler outlet with a plas-
tic bag to prevent water to come .
inside. Please do it only after the
engine/muffler in cool status.
2. Closed every caps, covers, electri-
cal connectors that are well install
and water can be avoid to get
into, while you do the clean job.
CAUTION:
Explorer do not suggest to use the
acidic cleaners for cleaning , but
ff such products have to been
used on hard-to-remove dirt, pl-
ease only do the spot cleaning
and use water, dry it and corro-
sion protection spray after finish.
Please only use mild detergent
and water to clean plastic covers,
panels, windshields, headlight
lenses, meter lenses, etc. After

SCOOTER CLEAN AND STORAGE

cleaning, use only a soft, clean
cloth or Spinge to dry the plastics.
Please prevent any harsh che-
mical products(like fuel, rusty
removers, break fluid...) on pla-
stic parts, especially on painted
covers, lens and wind shield. it
will damage/un-function them,
and even cause safety conside-
ration.
Do not use high-pressure wash-
er, steam cleaner since it will
cause water seepage and deter-
ioration on axle bearings, elec-
tric compenents as connec-
tors and switches, lights, brea-
the hose and tube, brake shoes
and pads and seals, due to the
pressure and heat.
For scooters equipped with a
windshield: Do not use strong
cleaners or hard sponges as
they will cause blur or
scratch. Only wash it by gentle
water and mild detergent.
7-1
After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge, and
then rinse thoroughly with clean water.
Use a toothbrush or bottlebrush for
hard-to-reach areas.
on salt-sprayed roads
Since sea salt or salt sprayed on the
roads during winter are extremely cor-
rosive in combination with water, carry
out the following steps after each ride
in the rain, near the sea or on salt-
sprayed roads.
NOTE:
Salt sprayed on roads in the winter may
remain exist into spring.
1. Clean the scooter with cold water
and a mild detergent after the en-
gine has cooled down.
EAU10122

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis