Hitachi RCI-1.5FSN1E Installationsanleitung Seite 13

CAUTION:
If tighten long screws insufficient, may cause
-
something wrong as below.
Air Leakage
Smudge Dewing
If any gap has even though tighten long screws
-
sufficient, readjust the height of indoor unit.
No gap shall exist
It's able to adjust the indoor unit height by using
-
wrench from the corner pocket.
Wrench
7.3. WIRING CONNECTION FOR AIR PANEL
1. The following connector is used with the air panel (view
from lower surface of air panel without air intake grille)
Electrical Control
Box
7.4. TEST RUN
After completing the installation of the air panel, a test run
should be performed by refering to I&O PMML0101A.
INSTALLATION OF OPTIONAL AIR PANEL: P-G23WA2
NOTE:
2. Connect the connectors as shown below (view of the
electrical box)
Connector for Auto
Swing Motor
(Low Voltage,
7Pin, Red)
Too considerable adjustment of height cause dewing
-
from drain-pain.
Do not turn the air louver by hand. If moved, the
-
louver mechanism would be damaged.
In case that the corner pocket is dismantled agter
installing the air panel:
1. "1" The corner position of the corner pocket ca be
lifted by inserting a "- " shaped driver and lifting.
By keeping this state, lift the "-" shaped driver in
the lower direction. The whole corner pocket can
be lifted. After disconnecting the fixing nails (3
positions), disconnect the L-shaped nail and
remove the corner poc1ket cover.
2. Slide the cover in the allowed direction.
Coin or Slotted Screwdriver
Lifting
7
9
Louver
Corner Position
Electrical Control Box for Indoor
Unit
PCB
Connector for Auto Swing Motor
(Low Voltage, 7Pin, Red)
CN17