Handling The Equipment - Kettler Favorit Montageanleitung

– EN –
all screw connections have been tightened firmly. Attention: once
locknuts have been unscrewed they no longer function correctly
(the locking device is destroyed), and must be replaced.

Handling the equipment

■
Before using the equipment for exercise, check carefully to en-
sure that it has been correctly assembled.
■
It is not recommended to use or store the apparatus in a damp
room as this may cause it to rust. Please ensure that no part of
the machine comes in contact with liquids (drinks, perspiration
etc.). This may cause corrosion.
■
The machine is designed for use by adults and children should
not be allowed to play with it. Children at play behave unpre-
dictably and dangerous situations may occur for which the ma-
nufacturer cannot be held liable. If, in spite of this, children are
allowed to use the equipment, ensure that they are instructed in
its proper use and supervised accordingly.
■
The rowing machine is a training device which works on a
stroke rate dependent basis (independent of speed).
Maintainance – Service – Spare Parts
■
Damaged components may endanger your safety or reduce the
lifetime of the equipment. For this reason, worn or damaged
parts should be replaced immediately and the equipment taken
out of use until this has been done. Use only original KETTLER
spare parts.
■
To ensure that the safety level is kept to the highest possible stan-
dard, determined by its construction, this product should be ser-
viced regulary (once a year) by specialist retailers.
■
Please ensure that liquids or perspiration never enter the ma-
chine or the electronics.
■
A few drops of viscous oil should be applied to the bearing
sleeves of the hydraulic absorbers and the rowing levers. Care
should be taken that the oil does not drip onto the floor!
■
After a longer period of disuse, the hydraulic absorbers may not
achieve their best performance at once. Before beginning exer-
cising or after a period of disuse, it is recommended to activate
the absorbers by several pumping movements.
■
For technical reasons, we reserve the right to carry out prelimi-
nary assembly work (e.g. addition of tubing plugs).
■
A slight production of noise at the bearing of the centrifugal
mass is due to the construction and has no negative effect upon
operation. Possibly occurring noise during reverse pedalling re-
sult from engineering and are absolutely safe.
■
The training device has a hydraulic brake system.
■
To operate correctly, the pulse function requires a minimum vol-
tage of 2,7 volts (only for computers working with batteries).
■
Before beginning your first training session, familiarize yourself
thoroughly with all the functions and settings of the unit.
■
When training intensivly shock absorbers may become very
hot. Please avoid contact and do not touch the shock absorbers
after training.
Spare parts order
■
When ordering spare parts, always state the full article num-
ber, spare-partnumber, the quantity required and the S/N of
the product (see handling).
Example order: Art. no. 07978-900 / spare-part no.
91280037 / 2 pieces / S/N ....................
Waste Disposal
KETTLER products are recyclable. At the end of its useful life please
dispose of this article correctly and safely (local refuse sites).
KETTLER GB Ltd.
GB
Kettler House, Merse Road
North Moons Moat
Redditch, Worcestershire B98 9HL
www.kettler.co.uk
KETTLER International Inc.
USA
1355 London Bridge Road
Virginia Beach, VA 23453
www.kettlerusa.com
+44 1527 591901
+44 1527 62423
e-mail: sales@kettler.co.uk
+1 888 253 8853
+1 888 222 9333
e-mail: sales@kettler.co.uk
5