Product Description; Size Of Motor (In Mm); Standard Installation; Technical Data - SOMFY AXOVIA 220B Installationsanleitung

Axovia 220B

2. PRODUCT DESCRIPTION

2.1. Size of motor (in mm)

166.12
938.83

2.2. Standard installation

2.3. Technical data

Motor power feed outputs
Power per motor
Operating temperature
Protection rating
3. PRE INSTALLATION CHECKS

3.1. Gate

The gate must be in good condition: ensure that its structure is suitable for
automatic control and that it conforms to the relevant standards.
The gate must remain horizontal throughout its travel, and must open and
close manually with ease.

3.2. Pillars

The pillars are out of plumb so require the use of an intermediate plate.
Furthermore, when one of the motor clamp mounting holes is not resting
on anything or is close to the angle of the pillar or wall, it is essential to
use the intermediate plate (ref. 2400485).
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.

3.3. Reinforcements

If the gate has no reinforcements, fit some metal reinforcement plates
(e.g.: 15x15 cm and 4 cm thick). to secure the brackets to the gate leaves.

3.4. Field of application

The Axovia 220B motorisation is designed to motorise a swing gate for a
single-family home.
175
4. PREPARING AND DRILLING OF PIL
For the indicated values, the gate leaves and their hinge pins are taken to
be on the same axis.
If the hinge pins are offset, the maximum opening angle values will be
reduced.
1) Measure dimension A.
2) Select dimension B in the table according to the required opening an-
24 Vdc
120 W
-20°C to +60°C
IP 44
3) Trace axis AM on the pillar copying dimension B onto the pillar.
H ≤ 2m
LARS
gle.
A (mm) max. α (°)
120
110
0
105
50 100
100 95
150 90
200 90
250 90
EN
P ≤ 200kg
B (mm)
205
160
150
150
150
150
150
150
4