Sure Flap Microchip Cat Flap Connect Bedienungsanleitung Seite 23

When using power tools, please follow all safety instructions
provided with the product.
5
6
7
8
9
10
11
Now it's time to prepare for cutting. We strongly advise that
you drill large holes in all the corners of the outline to make
it easier to cut the hole with a jigsaw. Make sure these holes
are touching the line and that they are big enough for the
blade of the jigsaw to fit through.
Using a jigsaw, cut around the inner edge of the line you
have marked. Once the hole is cut, to select the correct
length of screw from the sets provided, you need to compare
the screw lengths to the thickness of your door. The screw
length needs to be between 20 to 35mm (25/32 to 2 3/8'')
longer than the thickness of your door.
Apply a line of clear all-weather sealant to the back of both
mounting adaptors, about 15mm (9/ 1 6'') from the edge. Make
sure your Cat Flap is nearby and ready to be fitted. Place one
of the mounting adaptors (it doesn't matter which) over the
tunnel of the Cat Flap so that the patterned side with the ribs
is facing outwards and is not touching any surfaces.
We advise that there are two people present for this step;
one person inside the house and one outside. From inside
the house, put the tunnel through the hole in the door.
Remember the SureFlap logo must be inside the house.
From the outside of the house, check that the tunnel is in
the centre of the hole and not resting on the edge of the
hole, then take the second mounting adaptor and side it
over the tunnel with the sealant facing the door. You may
need the person inside the house to keep pressure on the Cat
Flap to make sure it stays in place.
Next, slide the external frame over the tunnel. The person
on the inside of the house should keep pressure on the Cat
Flap and hold it so that the tunnel is in the centre of the hole.
Using a cross head screwdriver and the length of screw you'd
chosen, secure the external frame in place. Fasten the first
screw until it is secure, but not too tight, then do the same to
the last one. Once all the screws are secure, tighten them.
Now, insert the two screw caps into the external frame.
EN
22