Set Up Your System - Sure Flap Microchip Cat Flap Connect Bedienungsanleitung

Set up your system

Once you have successfully downloaded the Sure Petcare app, you will need to plug in
your Hub and set it up. Once your Hub is set up you will be asked to connect it to both the
Cat Flap and the app. Please follow the steps below:
1
2
3
4
Your Hub may receive a software update. If you see solid red lights during
setup, don't panic, your Hub is updating its software. Once complete the Hub
will reboot and you'll see the light sequence detailed in step 3.
Plug one end of the Ethernet cable into the
base of your Hub and the other end into a spare
Ethernet port on your router.
Assemble the power supply and plug it into your
power outlet. Plug the other end of the cable into
the base of your Hub.
Your Hub's 'ears' will start alternating red and then
green. When both ears remain solid green your
Hub is ready. If the ears fail to do this sequence
please see page 14 for more information.
In order to complete the setup of your Microchip Cat
Flap Connect system you will need to follow the
remaining steps on the Sure Petcare app. Once all
the elements of your system are connected you can
start controlling your Cat Flap's features remotely!
EN
12