7. Anschließend biegen Sie das senkrecht hochstehende
Ende des Widerstandes um.
7. Afterwards bend the vertical end of the resistor.
7. Pliez ensuite l'extrémité verticale de la résistance.
7. Aansluitend buigt u het haakse eind van de weerstand
om.
8. Schieben Sie den Schrumpfschlauch auf die zuvor
hergestellte Kontaktstelle (Kabel + Widerstand).
8. Slide the heat shrink tube on the contact point which
was made prior to this (cable + resistor)...
8. Enfilez le tube thermorétractable sur la partie de contact
que vous avez créée (câble + résistance).
8. Schuif de krimpkous over de zojuist gemaakte contact-
plaats (draad en weerstand).
7