Locating Malfunctions Of Flexible Shaft And Pockers; Instructions To Order Spare Parts; Instructions To Request Warranties - Enar AX 25 Gebrauchsanweisungen

9.2 LOCATING MALFUNCTIONS OF FLEXIBLE SHAFT AND POCKERS

PROBLEM
The motor works overload
and overheats
Bearing failure

10 INSTRUCTIONS TO ORDER SPARE PARTS

10.1 INSTRUCTIONS TO ORDER SPARE PARTS
1.All spare parts request must include PART CODE NUMBER AS STATED IN THE PART LIST. We
recommend to include ITEM´S MANUFACTURE NUMBER.
2.The identification plate with manufacture and model number is located in the top part of the
motor`s plastic frame. The transmission and pokers have the manufacture number engraved outside.
3.Let us to know the correct shipping instructions, including the wished route and the address and
consignee`s complete name.

10.2 INSTRUCTIONS TO REQUEST WARRANTIES

1.The warranty is valid 1 year after the purchasing of the machine, The warranty will cover parts with
manufacture`s defects. In no case the warranty will cover a malfunction due to improper usage of the
equipment.
2.In all warranty requests
AUTHORIZED SHOP, always including the complete address and name of the consignee.
3.The Technical Assistance Service will immediately notify you if it accepts the warranty and if
requested, it will send a technical report.
The warranty will be void if any equipment has been previously handled by personnel outside of
ENARCO, S.A. or not authorized by it.
NB:
BACKPACK / VIB-BAR - FLEXIBLE SHAFT AND POKERS
1.- Head is overlubricated.
2.- Too much grease in shaft or too little.
3.- Failure of seal and the transmission grease have gone into the head or the head oil
have gone out.
4.- Head movement is restricted.
5.- Transmission with extreme bents.
6.- Transmission in bad condition, broken hose.
1.- Not enough oil in the head.
2.- The head has been working out of the concrete during a long time.
3.- Water has penetrated the head.
4.- The housing has received strong stroke.
ENARCO, S.A., reserves the right to modify any part of this manual without prior notice.
TDX0,7, TDX2m – BACKPACK / VIB-BAR
CAUSE/SOLUTION
THE MACHINE MUST BE SENT TO ENARCO, S.A. or to an
AX25, AX38, AX48
en
9