Getting Started; Shaft Conection To Power Unit; Poker Connection To Flexible Shaft; Inspection - Enar AX 25 Gebrauchsanweisungen

6.-
7.-
8.-
9.-

6.2 GETTING STARTED

Read item 5 USAGE CONDITIONS

6.3 SHAFT CONECTION TO POWER UNIT

Power unit is designed to facilitate a quick and safe connection to flexible shaft.
CONNECTION PROCEDURE:
1. Connect the transmission shaft to the square engine housing.
2. Screw plastic nut of shaft to aluminium thread of power unit . (Be aware of nut turns left and not
tool is required)
CONNECTION CHOICES :
FLEXIBLE SHAFT LENGTH:
VIBRATOR DIAMETER :
en

6.4 POKER CONNECTION TO FLEXIBLE SHAFT

The flexible shafts TDX are intended to connect the pokers: AX38 and AX48.
Allowing to interchange of a poker to other quickly and without a special tool. The model AX25, due to the
diameter need a special transmission. (TDXE).

6.5 INSPECTION

1. Before starting the job , check the correct working of all handling and safety devices
2. Inspect regularly the good condition of the transmission. When the hose is broken, repair it or
replace it to avoid damaging the shaft or the poker.
3. When notice wear parts, replace it.
4. If defects are found in the safety devices or other defects which could reduce the safe handling of
the equipment, notify immediately to proper responsible person.
AX25, AX38, AX48
6
TDX0,7m, TDX2m – BACKPACK / VIB-BAR
Check the oil reservoir of the motor is full (see engine manual) in the 4-stroke engine
(SAE10W40).
Check all the bolts are well tighten.
Start the motor, regulate the speed with the accelerator until it reaches a good vibration.
When a defect or a malfunction has been detected, endangering the use of this machine
or not, stop the work and make the correspondent maintenance to avoid any danger or
bigger damage.
BACK PACK: 2m. (TDX 2M, TDX-E 2M)
VIB-BAR: 0,7m. (TDX 0,7M, TDX-E 0,7M)
TO 48mm (AX25, AX38 and AX48)
CONNECTION PROCEDURE:
1-Introduce the hexagonal driver of the poker in the shaft.
2-Screw the poker on the screwed end of the transmission up to fasten with spanner. ( left
threads).
BACKPACK / VIB-BAR - FLEXIBLE SHAFT AND POKERS