Specific Safety Rules; Usage Conditions; Operation And Maintenance; Before Start - Enar AX 25 Gebrauchsanweisungen

4.5 SPECIFIC SAFETY RULES

For your own safety,
this equipment, please read carefully the instructions
1.-
2.-
3.-
4.-
5.-
6.-
7.-
8.-
9.-
10.- Do not operate in the motor shaft when this is working and without transmission
11.- Do not work with transmission or poker in bad conditions, the motor overheats.
12.- Do not permit untrained personnel to operate the motor or connections.
13.- Read the engine manufacturer's manual before working.
14.- Do not work in closed rooms, the exhaust fumes may be toxic.
15.- Wait 2 minutes for the petrol refill until the motor gets cold.
16.- Keep the air intake clean and opened for the correct running of the motor.
17.- The vibration that transmited to the operator does not exceed 2,5 m/s2 of acceleration.
(1,45 m/s2 obtained value).
IN ADDITION, LOCAL COUNTRY ESTABLISHED ORDINANCES SHOULD BE RESPECTED.
5

USAGE CONDITIONS

For your own safety, as protection for others, and to avoid damage to the equipment, read carefully
the usage recommendations.
1. Before working, to be sure the hose joint nut is fastened to the motor (screwed to left).
2. Be sure the poker is well screwed to the flexible shaft (screwed to left).
3. Do not work with flexible shaft with big bends.
4. Do not overlubricate the shaft.
5. Do not keep working the poker out of the concrete more than 5 minutes.
6. Do not restrict the movement of the poker during the work.
7. Do not stop the poker inside the concrete.
8. Change the wear parts to avoid damage to the internal parts. (Check wearing table for the poker)
9. Do the maintenance with the kinds and quantities of recommended lubricants.
6

OPERATION AND MAINTENANCE

6.1 BEFORE START

1.-
2.-
3.-
4.-
5.-
BACKPACK / VIB-BAR - FLEXIBLE SHAFT AND POKERS
as well as for the others one, and in order not to cause any damage to
For the proper use of this device, please assure that the operator has been correctly
informed of the content of this manual before using it.
This machine must be used only under the applications for which it has been designed
and according to these safety instructions.
Do not touch any part of the vibrating group when the motor is running.
Do not work in an area exposed to flammable liquids or gases.
Do not allow inexperienced or not trained personnel to use the machine.
Please secure all the threads and bolts before working.
Do not stop the machine until the concrete mass is fully vibrated.
Do not work with the machine if any type of dysfunction, even small, has been observed.
Do not connect the flexible shaft to the motor when this is working.
Before working, make sure that all the security devices are operating under normal
conditions.
Read the engine manufacturer manual.
Do not work in rooms with scarce ventilation.
Make sure there is no flammable good near to the escape.
Check the petrol level in the reservoir (use always unleaded gas in 4 stroke engines).
TDX0,7, TDX2m – BACKPACK / VIB-BAR
that are explained as follows:
AX25, AX38, AX48
en
5