Installation - Elica PANDORA IX / F / 90 Montage- Und Gebrauchsanweisung

Installation

Before carrying out the appliance in-
stallation, please check that all compo-
nents are not damaged, in such a case
contact your retailer and do not proceed
with any further installation step. In ad-
dition, carefully read all the instructions
specified below.
Use an air exhaust pipe whose maxi-
mum length does not exceed 5 meters.
• Limit the number of elbows in the pi-
ping, since each elbow reduces the air
capacity of 1 linear meter. (Ex. : if you
use no. 2 x 90 ° elbows, the length of
piping should not exceed 3 meters)
• Avoid abrupt direction changes.
• Use a 150 mm constant diameter pipe
for the whole length.
• Use piping approved by relevant stan-
dards in force.
• The manufacturer shall not be deemed
responsible for air capacity or noise pro-
blems caused by failure to comply with
the above instructions and no warranty
on the product shall be provided.
Before making the hole, check that the-
re are no structural, or other parts inside
the cabinet, where the appliance is to
be placed, which could hinder proper
installation.
Check that the dimensions of the hood
and the ones of the hob are compatible
with the cabinet, so that the installation
can be carried out properly.
• Make a rectangular hole in the rear
side of the cook top, of the following si-
zes: (Fig. 1)
822mm X 100mm.
If your appliance is supplied with the
motor already mounted, remove the
screws and the suctioning unit in order
to fit the downdraft into the hole made.
• Fit the hood into the hole made, by inser-
ting it from above , as shown in (Fig. 2).
Secure the hood inside the cabinet, by
using the specific fixing brackets pro-
vided (Fig.3). Fix the brackets into the
lower side of the hood, Before inserting
the screws into the cabinet, make sure
that the appliance is perfectly perpendi-
cular with the worktop.
In the case of internal motor version,
it is necessary to fit the power pack
by directing the air outlet towards the
desired position, either downwards or
upwards (Fig. 5). The motor can be fit
on both the front and rear side of the
downdraft. Once fitting the motor , the
air-outlet piping can be fit.
In the case of external motor version ,
the power pack ( external motor) shall
be positioned in a suitable place and
the air exhaust piping shall be fit. Install
the air outlet piping between the exter-
nal motor and the downdraft. Select the
air-out let among the 5 possible options
(Fig.6) and fit the pipe fitting supplied.
After completing installation and connec-
ting the appliance to the power supply, lift
up the downdraft by pushing on the front
piece seat, as shown in fig. 7.
Then fit the charcoal filters, if the product
is in the filtering version, ( charcoal filters
are not supplied with the appliance and
are purchasable in a specific kit) , the gre-
ase filters (see fig. 8), and finally the front
glass as shown in fig. 9; make sure to fit
the glass properly , as shown in fig. 10.
11