Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Place the metal box containing the
electronic components in an easily
reachable area for possible technical
assistance operations, by connecting
the electric connectors of the box to the
hood (fig. 11).
How the hood works
It is necessary to open the extractable
unit in order to ensure the appliance nor-
mal operation, by following these steps.
Push the glass downwards, as shown
in fig. 12; the glass will be released and
will open.
Following the extractable unit opening,
it will be possible to operate the suction
motor by using the push-button panel,
as follows.
To close the extractable unit, push on
the front glass until the extractable unit
is completely closed.
T1.
Timer ON/OFF key: press it to set the automatic
switching off:
Speed 1: 20 minutes
Speed 2: 15 minutes
Speed 3: 10 minutes
High Speed : 5 minutes
T2.
Key to decrease the aspiration speed (power).
OFF 1: press it multiple times, in order in order to re-
duce the aspiration speed until the hood is turned off.
OFF 2: hold it down for a prolonged period of time,
at any speed.
T3.
ON /aspiration speed (power) increase (1-2-3-High
speed) key.
The High speed lasts about 5 minutes: after that
speed 2 is automatically set.
Filter saturation indicator
The hood displays when it is necessary to carry out mainte-
nance on the filters:
Grease filter (about every 40 hours of use): all the Leds
with blue light will flash
Activated charcoal filter (about every 160 hours of use):
all the Leds with blue light, leds L2 and L3 will flash.
Filter saturation resetting
After performing the filter maintenance, press keys T1 and
T3, for a prolonged period of time, Leds L1, L2 and L3 will
flash shortly with a blue light, and then will turn off.
Enabling the activated charcoal filter saturation indica-
tor.
This indicator is usually disabled. Follow this procedure to
enable it:
With the hood turned off, press and keep T1 and T2 keys
pressed simultaneously for a prolonged period of time: at
first L1 will light up, followed by L2 and L3; then, when
the keys are released, leds L2 and L3 will flash shortly to
confirm that activation has been completed.
Disabling the activated charcoal filter saturation LED:
repeat the above mentioned procedure; at first leds L1, L2
and L3 light up simultaneously; then, when the keys are
released, leds L2 and L3 will turn off to confirm that deac-
tivation has been completed.
MAINTENANCE
Grease filter
It captures grease particles deriving from cooking.
It shall be cleaned once a month (or when the filter satura-
tion indicator - in case your model is equipped with this fe-
ature- displays that it is necessary), with mild detergent, by
washing it by hand or in the dishwasher at low temperature
and with a short cycle.
The metal grease filter may fade if washed in the dishwa-
sher, but its filtering characteristics will remain unchanged.
Activated charcoal filter (Filtering Version only)
It captures unpleasant odours deriving from cooking.
The charcoal filter saturation depends on the usage, on the
cooking style and on how often the grease filter is cleaned.
In any case, the filter shall be replaced at least every four
months.
After removing the grease filters, it is possible to fit the char-
coal filters (Fig. 8).
12
Werbung
