Viewing The Caller List; Dialling A Telephone Number Directly From The Caller List - switel T39 clip Bedienungsanleitung

6.1

Viewing the caller list

Before using the caller list, the CLIP caller list function must be switched on. You can switch
between the phone book and the caller list with the CLIP button. Therefore make sure that the
display message CLIP is on. You can page through the caller list using the jog dial. All calls
registered will be shown as follows:
Number has
been newly
registered
When you reach the last storage location in the list, the display will show the message END OF
LIST.
Note!
When all newly recorded numbers have been checked, the new call indicator light goes off and
the NEW indicator in the display shows 00.
If no button is pressed within 30 seconds, the caller list is no longer displayed and the display
shows the current time and date once more along with the number of telephone numbers stored
in the caller list and the number of newly stored telephone numbers.
6.2

Dialling a telephone number directly from the caller list

You can dial telephone numbers directly from the caller list.
1. Select the required telephone number using the jog dial.
2. Press the ENTER button. The display will show the message PICK UP HANDSET.
3. Now lift the receiver or press the handsfree button
message DIALING ... and the connection will be made.
− Caller Display (CLIP) −
Time/date of call
NEW 11:43 16/1
CLIP
0123456789
Store location in
the caller list
currently selected
08
b
. The display will show the
67