Description Of The Speed Scale X120 110 Volt Version; Exchanging The Homogenizing Shafts; Exchanging The Generator; Maintenance And Cleaning - CAT X120 Bedienungsanleitung

4.5.2 Description of the speed scale X120 110 Volt version:

5
12 2 28 35
RPM x 1
4.6

Exchanging the homogenizing shafts

Prior to exchange the homogenizing shaft disconnect the unit from the mains supply.
Loosen the holding screw (3) and firmly pull out the shaft by hand. It will disconnect easily.
When inserting another shaft, make sure that the coupling fits well. This can be easily
detected by the "click" that is heard when the coupling shaft has reached the end of the
coupling slot of the motor. Do not forget to securely fasten the holding screw (3).
4.7

Exchanging the generator:

The generators have sharp edges. Handle with care. Risk of injuries!
To exchange the generator (rotor and stator), always take the shaft out of the motor drive
unit as described above. For undoing the rotor, use the two special keys (to be ordered
separately). The socket wrench is used to counter-hold the shaft, and the rotor wrench to
undo the rotor. To exchange the stator, remember that the fastening thread is counter-
clockwise. You will find further detailed descriptions in the instruction manual which comes
with each homogenising tool.
Important Note
Always unscrew the rotor first before unscrewing the stator.

5 Maintenance and Cleaning

5.1

Cleaning the drive unit X120

To clean the drive use only water with a detergent that contains tensides or use
isopropylalcohol for stubborn soiling.
Bedienungsanleitung/Instruction Manual X120_2011/05 V1.04
Start the unit always at the lowest
speed and then gradually increase
the speed to the desired level.
Page/Seite 10 von/of 31