Trix G 2000 BB Bedienungsanleitung Seite 12

Notes on digital operation
• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
• The values set at the factory have been selected for mfx in
order to guarantee the best possible running characteristics.
Adjustments may have to be made for other operating
systems.
• The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC
power operation (CV 29/Bit 2 = 0).
mfx Protocol
Addresses
• No address is required; each decoder is given a one-time,
unique identifier (UID).
• The decoder automatically registers itself on a Central Station
or a Mobile Station with its UID.
• Name set at the factory: G2000-03 Railion
Programming
• The characteristics can be programmed using the graphic
screen on the Central Station or also partially with the Mobile
Station.
• All of the Configuration Variables (CV) can be read and
programmed repeatedly.
• The programming can be done either on the main track or the
programming track.
• The default settings (factory settings) can be produced
repeatedly.
12
• Function mapping: Functions can be assigned to any of the
function buttons with the help of the 60212 Central Station
(with limitations) and with the 60213/60214/60215 Central Sta-
tion (See help section in the Central Station).
DCC Protocol
Addresses
• Short address – long address – multiple unit address
• Address range:
1 - 127 for short address and multiple unit address,
1 - 10239 for long address
• Every address can be programmed manually.
• A short or a long address is selected using the CVs.
• A multiple unit address that is being used deactivates the
standard address.