Service Centre; Error Messages - inshape 17402 Gebrauchsanweisung

Folding
Hold the rear of the treadmill with one
hand and lift the horizontal section of the
treadmill up until the cylinder (10) engages
in the locked position.
You can now move the treadmill by tilting it
and moving it on the built-in wheels.
Unfolding
Take � rm hold of the rear of the treadmill
with one hand.
Tread on the pedal (9) so that the cylinder
(10) is released.
GB
Slowly lower the horizontal part of the
treadmill. Be careful not to trap your � ngers
under the treadmill!

Error messages

The computer may occasionally display
an error message. If the instructions in the
table do not remedy the error, contact the

service centre.

Code Action
E2 Make sure that the emergency
stop is not pressed down.
E3 Check that the signal wire is
correctly connected.
E4 If the code is only displayed
when pressing the Start button,
check that the motor wire is
correctly connected.
E5 Check the motor wire.
E6/E7 Allow the treadmill to cool for 30
minutes and lubricate the belt
with silicone oil.
40
Service centre
Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• Open weekdays from 07.00 to 17.00
(Fridays until 15.00)
• E-mail: service@hpschou.com