inshape 17402 Gebrauchsanweisung Seite 37

Functional check before use
Before the treadmill is connected to the
power, you must check that the belt can
move unhindered and without noise on the
rollers.
Make sure that the emergency stop is not
pressed down.
Plug the treadmill in so it goes into standby.
Press the Start button. The belt begins to
slowly turn.
Press the Speed+/Speed-/6/8/10/12/14/16
buttons.
Check that the belt speed changes
accordingly.
Press the Stop button to stop the treadmill.
Use
Make sure that the emergency stop is not
pressed down.
If you suddenly need to stop the treadmill
quickly, press the emergency stop.
You can connect an MP3 player to the MP3
socket on the computer so you can listen
to music as you exercise. Turn the music
on and off using the MP3 On/Off button.
Turn the volume up and down using the
Vol+/Vol- buttons.
Press the Start button. The belt starts to run
at 1 km/h after 3 seconds.
Press the Speed+/- buttons to increase
or reduce the speed. The speed can be
adjusted from around 1 to around 18 km/h.
You can also select a speed of 6, 8, 10, 12,
14 or 18 km/h directly by pressing the
equivalent buttons.
Press the Incline +/- buttons to adjust the
incline of the treadmill.
You can also select an incline of 5, 7, 9,
11, 13 or 15 % directly by pressing the
equivalent buttons.
If you want to use the computer's
pulsometer function, you must position
your hands over the pulse sensors.
Reduce the speed, adjust the incline to
0 and press the Stop button to stop the
treadmill.
DK
NO
SE
FI
GB
DE
ET
37