Preparations For Assembly; Assembly And Preparation; Special Safety Instructions - inshape 17402 Gebrauchsanweisung

The treadmill may be used by children
over 8 years old and people with reduced
sensitivity, or a physical or mental disability,
as long as they are supervised or have been
instructed in use of the equipment in a
safe manner and have thus understood the
associated risks. Children must not play with
the treadmill. Cleaning and maintenance
must not be carried out by children unless
they are supervised.
When the treadmill is in use, it should be
monitored continuously. When the treadmill
is in use, any children near it must not be
left unattended. The treadmill is not a toy.
Remember to check your treadmill
regularly. Tighten all screws, bolts and nuts
on the treadmill as required. Inspect the
treadmill and replace any worn parts. Do
not use the treadmill if it is defective.
When moving the treadmill, employ the
correct lifting technique.
The treadmill is only intended for indoor use
in private households.

Special safety instructions

Do not place your � ngers or other objects
near the belt when it is moving.
Do not use the dead man's switch to start
and stop the belt.
Once you have stopped the belt, wait at
least 3 seconds before starting it again. Do
not run faster than the belt rotates, as this
may damage the treadmill.
Use soft and non-marking shoes when
running on the treadmill.
WARNING! The pulse monitor may be
inaccurate. Training too hard may involve a
risk of personal injury or death. If you feel
unwell, stop exercising immediately.

Preparations for assembly

Two people are required to assemble the
treadmill.
Lay all the pieces out on the � oor and check
that all the parts are there.
Please refer to the illustration and parts list
at the back of the manual.
You must use the following tools:
• Allen key
• Screwdriver

Assembly and preparation

Remove the treadmill from the packaging
and wipe it with a soft cloth.
Place the coverplates over the legs on the
upright frame. Pull the signal wire through
the tubing in the leg on the upright frame.
Insert the legs into the sockets on the
horizontal frame so that the upright frame
is upright.
DK
NO
SE
FI
GB
DE
ET
35