Canton Smart Vento 9 Bedienungsanleitung Seite 97

Problem Possible cause
One or more spe- 1� The parameter ASM is set to DST and the
akers do not play a source device is connected to the same Line
signal when the Line connector (left resp� right) of both speakers�
or Balanced input is
selected�
2� The source device was connected only
to the master speaker�
From one of the The parameter SLC is set to WRD but the
speakers, there is master was not connected to the slave
no sound� via a coaxial cable�
The speaker system 1� The source device on the coaxial or optical
does not change in- digital input has not been switched off or the
puts automatically� source device does not switch off its S/PDIF
transmitter in standby mode�
2� The signal at the Line, Balanced or USB input
is too low�
Solution
1� If the parameter ASM is set to DST, be sure to connect the
left channel of the source unit to the jack marked L of the
left speaker and the right channel of the source unit to the
jack marked R of the right speaker�
2� If balanced (Analogue Balanced) input is selected, the
source must be connected directly to all speakers� Here,
pay attention to the correct channel assignment as well�
If the SLC parameter is on WRD, there must be a cable
connection between the master digital coaxial output and the
slave digital coaxial input� If this is not the case, set
the parameter to WLS or establish the cable connection�
1� In order to switch from the coaxial or optical digital input,
the source device must be switched off�
2� Increase the output level on your source device�
English
3 9 9