Technical Data - Hilti TE 905-AVR Bedienungsanleitung

4. Technical data

Tool
Rated power input
Rated voltage
Rated current input
Mains frequency
Weight as per EPTA-Procedure 01/2003
Dimensions (l×w×h)
Chuck
Hammering speed under load
Single impact energy
Chiseling performance in medium-hard concrete
Permanent lubrication
Adjustable side handle
Foam rubber padded grip and side handle
Electronic speed (r.p.m.) limitation
On/off switch
Vibration reduction with built in AVR-system
Service indicator
User information as per EN 61000-3-11
Switching operations cause short voltage drops. If the mains electric supply conditions are unfavourable, other
tools / machines can be impaired. If the main electric supply impedance is less than 0.39 Ohms, no disruptions
/ disturbances need be expected.
Double insulated (in accordance with EN 60745)
Interference immunity
Radio and television interference suppression
-NOTE-
The vibration emission level given in this information sheet has been measured in accordance with a standardised
test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assess-
ment of exposure. The declared vibration emission level represents the main applications of the tool. However if
the tool is used for different applications, with different accessories or poorly maintained, the vibration emission
may differ. This may significantly increase the exposure level over the total working period. An estimation of the
level of exposure to vibration should also take into account the times when the tool is switched off or when it is
running but not actually doing the job. This may significantly reduce the exposure level over the total working
period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain
the tool and the accessories, keep the hands warm, organisation of work patterns.
Noise and vibration information (measured in accordance with EN 60745):
Typical A-weighted sound power level (L
Typical A-weighted sound pressure level (L
For the given sound power level as per EN 60745, the tolerance is 3 dB.
Wear ear protection!
Triaxial vibration value (vibration vector sum) measured in accordance with EN 60745-2-6
Chiselling, (a ):
h, Cheq
Uncertainty (K) for triaxial vibration value
Right of technical changes reserved
Printed: 07.07.2013 | Doc-Nr: PUB / 5071242 / 000 / 00
TE 905-AVR
1550 W 1600 W
100 V
15 A
50–60 Hz
12.3 kg
680×110×240 mm
TE-S
2200 blows/min
20 joules
1300 cm
Protection class II Z
In accordance with EN 55014-2
In accordance with EN 55014-1
): 105 dB (A)
wA
): 94 dB (A)
pA
8.5 m/s 2
1.5 m/s 2
1600 W 1600 W 1600 W
110 V 120 V 220 V
16 A 15 A 8.3 A
3 /min
230 V 240 V
8.3 A 8.3 A
en
13