Autoadapt DTS Gebrauchsanweisung Seite 29

Setting the desired default values
1
The values entered and saved here
are default values which will be visible
on screen during the various tests. All
values can be altered in the relevant
test window, but will then only be valid
for the test instance in question Values
automatically return to default values
after the test is completed.
Log in with the password / autoadapt.
Press Options A and then Default
Power B.
2
Areas for green bars C
This is where the area can be adjusted
for the green bars which show the
values the driver should try to achieve.
Green bars occur in several tests.
3
Scales max value D
This is where the maximum value for
scales can be adjusted. Note that the
value can never exceed the maximum
value created on calibration. Scales
occur in several tests. The lower the
maximum value the more accurate the
measured values.
4
Timer test E
This is where the start and stop value
for the timer test can be adjusted.
5
Emergency Brake Test F
This is where the start and stop value
for the emergency brake test can be
adjusted.
6
6-point reaction test G
This is where the value can be adjusted
which influences when the green and
red arrows go out on the 6-point reac-
tion test.
7
Save H
B
C E
D
F
Autoadapt Driver Test Station DTS
A
G
H
29
EN