Autoadapt DTS Gebrauchsanweisung Seite 27

1
Log in with the password / autoadapt.
Press Options A and then Calibration
B.
2
From the drop-down list C, select
the axle which is to be calibrated. All
alternatives are shown in chronological
order on the left of the screen.
3
Press D to reset the value from the
sensor in column D1 and from the
calibration tool in column D2.
4
Press E to reset the value on the sen-
sor for the selected axle.
Now new values must be created for
columns D1 and D2*.
The calibration tool is not used for the
first value. Press F to move the value
0.00 from the sensor to column D1.
Enter the value 0.00 in column D2.
5
Press E to reset the value on the
sensor for the selected axle. Use the
calibration tool as instructed on the
previous page to calculate a new value.
6
Press F to move the value from the
sensor to column D1.
7
Enter the value from the calibration
tool in column D2.
8
Repeat steps 5, 6 and 7 until all values
in columns D1 and D2 are updated.
9
Save the calibration. Switch to the next
axle and repeat steps 1-9. Once all
axles have been calibrated and saved,
return to the main menu.
B
* We recommend that the DTS is calibrated to the applicable standard
or a minimum of /
20 kg for steering
40 kg for hand controls
50 kg for pedal
Autoadapt Driver Test Station DTS
A
E
F
D1
27
EN
C
D
D2