Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL RT-VE 550 A Originalbetriebsanleitung

Anleitung_RT_VE_550_A_SPK1__ 15.11.13 11:30 Seite 16
GB
position "AUTO" = Automatic mode.
As soon as you switch on the electric tool the
extractor system will start up.
When you switch off the electric tool, the extractor
system will switch off as well after a pre-set delay.
8.4 Emptying the sawdust bag
Inspect and empty the sawdust bag (6) regularly!
Important: Remove the power plug!
Hold the filled sawdust bag in place with one
hand.
Open the quick clamp device (5).
Remove the bag and dispose of the contents in
an environmentally-friendly fashion.
Put the bag back into the holder and secure with
the quick clamp device (5).
8.5 Transportation (Fig. 6)
The vacuum extraction system has a standard
chassis (8).
For transportation, gently lift the vacuum
extraction system by the transportation handle
(4) and move it to the desired location.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
9.2 Maintenance
There are no parts inside the equipment which
n
require additional maintenance.
16
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.