Tool Specifications; Declaration Of Conformity; Noise/Vibration Information; Battery Charging - Würth SBS 10-A Originalbetriebsanleitung

Tool Specifications

Sabre saw
Article number
Rated voltage
Stroke rate at no load n
Stroke
Cutting depth, max.
– in wood
– in non-alloy steel
– Pipe diameter
Weight according to
EPTA-Procedure 01/2003

Noise/Vibration Information

Measured sound values determined according to
EN 60745.
Typically the A-weighted noise levels of the product
are: Sound pressure level 70 dB(A); Sound power
level 81 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a
uncertainty K determined according to EN 60745:
Cutting board: a =8,0 m/s
h
Cutting wooden beam: a
2
K=1,5 m/s .
The values given for sawing particle board apply for a
workpiece thickness of 20 mm.
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is
used for different applications, with different accesso-
ries or poorly maintained, the vibration emission may
differ. This may significantly increase the exposure
level over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as: main-
tain the tool and the accessories, keep hands warm,
organise work patterns.
SBS 10-A
0700 202 X
V=
-1
min 0 – 3000
0
mm
mm
mm
mm
kg
(triax vector sum) and
h
2 2
, K=1,5 m/s ,
2
=12,0 m/s ,
h

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Tool Specifications" is in
conformity with the following standards or standardi-
10,8
zation documents: EN 60745 according to the provi-
sions of the directives 2011/65/EU, 2004/108/EC,
14,5
2006/42/EC.
Technical file at:
65
Adolf Würth GmbH & Co. KG, Abt. PFW
8
74650 Künzelsau
50
1,2
T. Klenk
General Manager
Künzelsau: 25.04.2012
Note: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The Lithium-Ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The Lithium-Ion battery is protected against deep dis-
charging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched off
by means of a protective circuit: The inserted tool no
longer rotates.
WARNING
machine has been automatically switched off.
The battery can be damaged.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
Observe the notes for disposal.
Removing the Battery (see figure A)
• To remove the battery 11 press the unlocking but-
tons 5 and pull out the battery downwards. Do
not exert any force.
A. Kräutle
General Manager

Battery Charging

Do not continue to press the
On/Off switch after the
16