Assembly And Basic Adjustments - Omnitronic BD-1320 Bedienungsanleitung

19 Analog audio output (stereo RCA)
For connection to a line input or phono input, e.g. of an
amplifier or mixer.

5. ASSEMBLY AND BASIC ADJUSTMENTS

The headshell, the turntable platter, the counterweight for the tone arm, and the dust cover are separately
packed to prevent damage to the turntable during transportation. After unpacking, the parts can be easily
assembled. The packing material should be kept for transportation purposes.
5.1 Mounting the turntable platter
1 Place the rubber driving belt over the bottom of the platter (Fig. 1).
2 Set up the turntable on a plane, stable ground and place the turntable platter on the axle of the turntable
(Fig. 2).
3 Turn the platter by hand until one of the cutouts is near the top right corner and the driving axle of the
motor is visible.
4 The rubber driving belt is visible through the cutouts of the turntable platter. Seize the driving belt and
place it over the driving axle (Fig. 3).
5 Place the supplied slipmat on the turntable platter.
5.2 Mounting the headshell and the counterweight for the tone arm
1 Take the headshell out of one of the two lateral polystyrene wrappings, place it onto the front end of the
tone arm, and secure it with the locking nut.
2 Take the counterweight out of one of the two lateral polystyrene wrappings and place it on the rear end
of the tone arm until it locks into the place. The counterweight is then used for precise adjustment of the
stylus pressure on the record.
20 Ground terminal GND
21 Mains cable for connection to a socket
18/22 00042383.DOC, Version 1.0