Dmx-Protocol; Cleaning And Maintenance - EuroLite TF-5 Bedienungsanleitung

DMX-protocol

Control channel 1 - Gobo-wheel, gobo-shake
DMX-Value Feature
0-5 Blackout
6-39 Strobe-effect
40-45 Open
46-51 Gobo 1
52-57 Gobo 2
58-63 Gobo 3
64-69 Gobo 4
70-75 Gobo 5
76-81 Gobo 6
82-87 Gobo 7
88-93 Gobo 8
94-99 Gobo 9
100-105 Gobo 10
106-111 Gobo 11
112-117 Gobo 12
118-123 Gobo 13
124-129 Open
130-135 Gobo 1 shake with increasing speed
136-141 Gobo 2 shake with increasing speed
142-147 Gobo 3 shake with increasing speed
148-153 Gobo 4 shake with increasing speed
154-159 Gobo 5 shake with increasing speed
160-165 Gobo 6 shake with increasing speed
166-172 Gobo 7 shake with increasing speed
173-177 Gobo 8 shake with increasing speed
178-183 Gobo 9 shake with increasing speed
184-189 Gobo 10 shake with increasing speed
190-195 Gobo 11 shake with increasing speed
196-201 Gobo 12 shake with increasing speed
202-207 Gobo 13 shake with increasing speed
208-225 Stop
226-255 Cont. gobo-wheel rotation with increasing speed
Control channel 2 – Flower Rotation
DMX-Value Feature
0-26 Stop
27-130 Red with increasing speed
131-149 Stop
150-255 Red with decreasing speed

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
27/55 51785860_V_1_2.DOC