Nolan N91 EVO Sicherheit Und Gebrauchsanleitung Seite 13

• VISOR MECHANISM SYSTEM
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 By pressing the visor release button (A), slide the visor forwards until you hear a click
(Fig. 4).
1.3 Release the visor fastenings (B 1 and B 2) from their seat (Fig. 5).
1.4 Repeat the same steps on the other side of the helmet.
Important!: do not remove the visor's opening and closing mechanisms from the chin-
guard.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor fastenings (B 1 and B 2) into their seats
in the visor mechanism (Fig. 5).
2.2 Insert fastening B 1 in the housing provided and press the visor against the shell in line
with fastening B 2.
2.3 Slide the visor backwards until the visor locks into place.
2.4 Repeat the same steps on the other side of the helmet.
WARNING!
- Make sure that the system is working properly. Open the visor. By lifting the chin-
guard, the visor closes automatically.
- Do not use the helmet if the visor has not been assembled properly.
- If the visor opening/closing mechanisms are not working properly or if such mech-
anisms get damaged, please contact a Nolan authorized dealer.
•
(Available as standard or optional accessory)
1 PINLOCK ® INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment
external levers are turned inwards.
1.3 Place the Pinlock
Pinlock ® inner visor should be in contact with the inner surface of the visor.
1.4 Insert one side of the Pinlock
(Fig. 6).
1.5 Widen the visor and fasten the other side of the Pinlock
(Fig. 7).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
cone-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both visors
are correctly fastened and do not move. If the inner visor is not tightly fixed to the visor, move
the external adjustment levers simultaneously upwards to increase the stretch (Fig. 8). This
operation must be carried out gradually. The maximum stretch is achieved when the pin
adjustment external levers are turned outwards.
® inner visor on the visor. WARNING: The silicone-sealed profile of the
® inner visor on one of the visor pins and hold it in position
® inner visor to the second pin
® inner visor and check that the entire sili-
13