Care And Maintenance; Replacing The Clamping Jaws; Troubleshooting; Accessories - Rothenberger R 140 B Bedienungsanleitung

4

Care and Maintenance

The equipment should be handled with care and cleaned regularly.
After every use the screws and tools should be cleaned and treated. We recommend our special
cleaning agent „ROWONAL".
Care and maintenance of the gasoline motor must be according to the specifications of the
manufacturer. After five operating hours the first oil change is necessary. For other oil changes
use the same oil type. Changing of the air filter must be according to the specifications of the
manufacturer
The machine has a lubricating point (S) at the drive shaft in the area of
the clamping jaws, which has to be lubricated using a universal grease
after ten hours operation in each case. In general, all mobile parts in the
area for stressing the clamping jaws are to be cleaned regularly.
4.1

Replacing the clamping jaws

 Dismantle the front cover.
 Release the two cylinder screws on the front cap.
 Remove the front cap.
 Remove the individual clamping jaws and replace by new ones.
 Install in the reverse order.
5

Troubleshooting

Symptom
The machine does not start
Spiral does not rotate when
the hand-lever has been
operated
6

Accessories

Accessory Name
Welder's glove, left
Welder's glove, right
ROWONAL rust remover (5 l)
ROWONAL spiral combi-spray (0.2 l)
Guide tube 4m
Segregation key
Spiral/tool set standard 32m
Rod adapter
16
Possible Reason
No benzine
fuel tap is closed
Motor faulty
Clamping jaws worn
Drive belt worn
ROTHENBERGER Part Number
72120
72121
72140
72142
72559
72101
072962X
H99120
www.rothenberger.com
ENGLISH
Solution
Re-filling benzin
Open fuel tap
Contact our Customer Ser-
vice Department
Replace clamping jaws
Replace drive belt