Maintenance Instructions; Procedures In The Event Of Faults - Calira LG 616-DS/IU Gebrauchsanweisung, Einbauanweisung

Parallel operation
In parallel operation, the current drawn up by electrical equip-
ment should be less than the maximum charging current of
16 A. This is the only way to ensure that the battery is being
charged even though consumers are being supplied.

Maintenance instructions

The device must always be disconnected from the
mains before any maintenance!
Clean the device and the ventilation slots with a dry, lint-free
cloth.
24

Procedures in the event of faults

The device is maintenance-free. However, if any faults do
occur, please proceed according to the following table:
Fault Action
The battery is not being – Check all connections from the
charged.
– Check the fuses and the mains
– Start the motor and let it run
The voltage of the
Battery II has dropped
to below 1.5 V; the
mains charging process
does not start.
– The device overheats. Ensure
The maximum charging
current is not reached.
Please contact the manufacturer.
None of the faults
described here seems
to apply. But the device
still does not work.
charger to the battery. Pay at-
tention to the correct polarity.
Unplug the female device plugs
on the device and unclamp the
batterie. The device should be
disconnected from all power
sources. Clamp the batterie
on again and then plug in the
female device plugs. Check the
fuses and the mains connection.
connection.
for approx. 30 seconds. Battery
voltage rises above 1.5 V.
The charging process starts
automatically.
better ventilation of the device.