Installation Instructions; Safety Instructions; Setting Up; Accessories - Calira LG 616-DS/IU Gebrauchsanweisung, Einbauanweisung

Installation instructions

Safety instructions

This device contains components that may generate
sparks or electric arcing!
Connecting the device to the power supply must comply with
the applicable national installation regulations.
This battery charger contains components that may generate
electric arcing and sparks. Therefore when operating the
charger in a garage or a similar location, it must be contained
in a room or housing designed for this purpose!
When using this charger in caravans, mobile homes and boats,
the charger and the battery must be installed with physical
separation between them and in well-ventilated boxes!
The installation and connection of electrical apparatus must
always be performed by appropriately trained personnel!
Always make sure that the power supply is disconnected! Pull
out the mains plug!
When connecting the device, use only the supplied parts and
the specified cable cross-sections and fuses!
Only use suitable and undamaged tools.
Only connect the device according to the supplied connection
diagram!
20

Setting up

Remove the items packed separately (accessories) from the
main carton, and check them for completeness:
– 1 connecting cable 230 V, 1 m
– 1 Fuse 30 A
– 1 Fuse holder
– 4 Fastening screws
– 1 instructions for installation and use

Accessories

(not included)
Quick connector for battery "Quick power"
(part no. H10 432 0110 00)
Temperature sensor for battery
(part no. H10 012 0003 00)
Charge control panel LK-Panel II
(part no. H10 012 0142 00)
The device should be set up in a location not exposed to hu-
midity and damp. The setting up location must be clean, dry
and well-ventilated. During operation, the housing may heat
up to approx. 75 °C. Therefore maintain a minimum clear dis-
tance of 100 mm and make sure that the ventilation slots are
not covered.
The installation space for the charger must be no less than
the dimensions given as follows, to ensure that a minimum
all-round distance of 100 mm is maintained.
Length: 420 mm / Width: 410 mm / Height: 190 mm
The separate box for the device must be provided with ventila-
tion holes at the top and sides, with a total area of 100 cm².