Content Of The Package; System Requirements - i-tec U3HDMIDVIDOCK Gebrauchsanweisung

USB 3.0 Dual Docking Station
INTRODUCTION
Thank you for purchasing the i-tec docking station that will allow you to connect your
favorite pieces of hardware such as a keyboard, mouse, external disk or USB printer
through the USB ports, audio system through the input for earphones and microphone,
internet modem / LAN Ethernet PC network through the LAN port, monitor through the
DVI-I and HDMI port, etc. to your notebook / tablet / PC. You can connect all of these
pieces of hardware easily and fast to your notebook / tablet / PC by a single USB 3.0
cable. You can display your data on modern LCD and plasma monitors and TV sets
because the docking station is equipped with a DVI-I and HDMI port. The graphic chip
which makes the "heart" of the docking station supports even the Full HD+ resolution
(2048 x 1152 pixels). Each of the six USB ports (1x USB 3.0 Fast, 1x USB 3.0 and 4x USB
2.0) can be used for charging but only the port marked USB 3.0 Fast has a function in
accordance with the BC 1.2 specification (for charging of the iPad or Samsung tablets).
Another advantage is that the docking station can be used either in a vertical or a
horizontal position.

CONTENT OF THE PACKAGE

• i-tec USB 3.0 docking station
• Base plate
• Power adapter
• USB 3.0 cable (one end connector type A, the second end type B; 100 cm) – for
connecting to a notebook / PC
• Quick Start

SYSTEM REQUIREMENTS

• Hardware requirements: notebook / tablet / PC with a free port USB 3.0 / 2.0. If you
have USB 2.0, the data transfer speed will be reduced. Processor Intel Pentium 1.2 GHz
and higher, 512 MB RAM.
• Operating system: Windows Vista / 7 / 8 / 8.1 / 10 32/64 bit, Mac OS X, Linux Ubuntu
14.04, 16.04, 17.10, Android 5 (Lollipop) a higher
• For playing a DVD on an additional monitor the processor shall be at least Intel
Pentium 2.0 and higher, 1 GB RAM and a screen resolution shall be 800x600 and 16
colors.
CAUTION!
Charging: The docking station supports charging of the connected USB mobile
equipment such as smartphones, ebook readers, multimedia players, GPS navigations
and tablets (e.g. Asus, Toshiba, Dell, GoClever, Prestigio, Emgeton, Sencor). Simply
connect the equipment you want to charge using the original cable to the USB port of the
docking station with the connected power adaptor. The only exceptions are the Apple or
Samsung tablets which are supported as well but only on the USB 3.0 Fast port with the
BC 1.2 specification. At the same time the docking station must be disconnected from
the computer/notebook and the inclosed power adaptor must be connected.
USB 3.0: Before the installation on the USB 3.0 port make sure that you have the most
recent drivers installed for this port (for the USB 3.0 controller into notebook / tablet
/ PC). Products with the USB 3.0 SuperSpeed technology have been used since 2010;
however, the drivers for the supported equipment are still undergoing some fine tuning.
Your notebook / tablet / PC needs to be equipped with the USB 3.0 interface so that you
can utilize the advantages of the fast USB 3.0 equipment. Its problem free function is
ensured by the chipset which needs to have the current drivers available.
Problems that you can encounter during the installation or use of our USB 3.0 equipment
are very often caused by the installed outdated drivers for the USB 3.0 controller or
4 | ENGLISH
chipset of your notebook / tablet / PC. Other problems can be caused by outdated
firmware of the USB 3.0 port controller. Most frequently it is one of the following
manufacturers: Intel, Renesas (former NEC), Via (VLI), AS Media, Fresco Logic, Etron.
You can find the most recent drivers for the i-tec products on our website www.i-tec.cz/en
in the „Download" tab for the individual products.
INSTALLATION OF DRIVERS IN WINDOWS VISTA / 7 / 8 / 8.1 / 10 (32/64 BIT VERSION)
Before the first use do not connect the docking station to the notebook / tablet / PC, until
you install the corresponding drivers for the LAN and DVI-I. The equipment drivers need
to be installed only before the first use.
Download the required software from our website www.i-tec.cz/en from the „Download"
tab for this product. Install the drivers according to the following procedure:
For the LAN and DVI-I port run the downloaded file, select the language of the installation
and follow the instructions on the screen.
Note:
In Windows Vista / 7 / 8 / 8.1 / 10 install the DVI-I port as the „Administrator". The monitor
may be flashing during the installation of the drivers – this is a standard process. After
the completion of the installation we recommend restarting the notebook / tablet / PC.
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION TO A
NOTEBOOK / TABLET / PC)
1. Turn ON the notebook / tablet / PC and connect the power adapter to the docking
station.
2. Connect the power adapter to the AC 110 V / 230 V mains.
3. Connect the USB 3.0 cable to the USB port type B on the back on all of the docking
station.
4. Connect the USB 3.0 cable to a free USB 3.0 / 2.0 port of your notebook / tablet / PC.
5. Subsequently, the automatic installation of the ports in the individual systems will
start.
INSTALLATION OF DRIVERS IN MAC OS X
Before the first use do not connect the docking station to the MacBook / PC, until you
install the corresponding drivers for the LAN and DVI-I port. The equipment drivers need
to be installed only before the first use.
Download the required software from our website www.i-tec.cz/en from the „Download"
tab for this product. Install the drivers according to the following procedure:
For the LAN and DVI-I port run the downloaded file. Decompress the file on the desktop
of your MacBook / PC as a virtual disc, select "Drivers" and then „DisplayLink Software
Installer". Then select the language of the installation and follow the instructions on
the screen. Enter the user password if necessary. The monitor may be flashing during
the installation of the drivers – this is a standard process. After the completion of the
installation restart the MacBook / PC.
Quick Start
ENGLISH | 5