Trouble Shooting - Hoover Otsein OHDC7X Gebrauchsanleitung

40000443English.fm Page 15 Friday, August 8, 2003 6:22 PM

Trouble shooting

Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
● Have you selected the correct drying
time/programme? Go to page 11.
● Were the clothes too wet? Were the
clothes thoroughly wrung or spin-
dried?
● Does the filter need cleaning? Go to
page 9.
● Does the condenser need cleaning? Go
to page 10.
● Is the dryer overloaded? Go to page 8.
● Are the inlets, outlets and base of the
dryer free from obstructions?
● Has the 'CLASE TEJIDOS' button
been selected from a previous cycle?
Go to page 12.
The dryer does not operate:
● Is there a working electricity supply to
the dryer? Check using another
appliance such as a table lamp.
● Is the plug properly connected to the
mains supply?
● Is there a power failure?
● Has the fuse blown?
● Is the door fully closed? Go to page 13.
● Is the dryer switched on, both at the
mains supply and at the machine? Go to
page 12.
● Has the drying time or the programme
been selected? Go to page 12.
● Has the machine been switched on
again after opening the door? Go to
page 9.
● Has the dryer stopped operating
because the water tray is full and needs
emptying? Go to page 10.
Limpieza Filtro Indicator on
● Does the filter need cleaning? Go to
page 9.
Recipiente Lleno Indicator on
● Does the water container need
emptying? Go to page 10.
Drum Light does not operate
● The drum light bulb can be replaced by
unscrewing the glass cover and
unscrewing the bulb. The bulb should
be replaced by type E14 (10W, 240V).
If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from Hoover
Service or an authorised Hoover Dealer.
Should there still be a problem with your
dryer after completing all the
recommended checks, please call Hoover
Service for advice. They may be able to
assist you over the telephone or arrange for
a suitable appointment for an engineer to
call under the terms of your guarantee.
However, a charge may be made if any of
the following applies to your machine:
● Is found to be in working order.
● Has not been installed in accordance
with the installation instructions.
● Has been used incorrectly.
ENGLISH
15