Trouble Shooting - Hoover OHDV 7 EX Gebrauchsanleitung

40000489-English.fm Page 11 Wednesday, August 27, 2003 10:34 AM

Trouble shooting

Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
● Have you selected the correct drying
time/program? Go to page 7.
● Were the clothes too wet? Were the
clothes thoroughly wrung or spin-
dried?
● Does the filter need cleaning? Go to
page 6.
● Is the dryer overloaded? Go to page 5.
● Is the venting hose kinked or blocked?
Go to page 4.
● Is the load too small? Go to page 9-10.
● Has the 'CLASE TEJIDOS' option
been selected from a previous cycle?
Go to page 8.
● Is the sensor system clean? Deposits
from the water may form over the
sensor plate. Go to page 10 "Cleaning
the dryer".
The dryer does not operate:
● Is there a working electricity supply to
the dryer? Check using another
appliance such as a table lamp.
● Is the plug properly connected to the
mains supply?
● Is there a power failure?
● Has the fuse blown?
● Is the door fully closed? Go to
page 9-10.
● Is the dryer switched on, both at the
mains supply and at the machine? Go to
page 8.
● Has the drying time or the program
been selected? Go to page 8.
● Have you pressed the 'START' button
to begin the program? Go to page 9-10.
● Has the 'MARCHA DIFERIDA'
option been set and is there still time
remaining? Go to page 9-10.
● Has the 'START' button been pressed
after opening the door? Go to page 6.
Filter Care Indicator on
● Does the filter need cleaning? Go to
page 6.
● Is the venting hose kinked or blocked?
Go to page 4.
If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from GIAS
Service or an authorised dealer.
Should there still be a problem with your
dryer after completing all the
recommended checks, please call Service
for advice. They may be able to assist you
over the telephone or arrange for a suitable
appointment for an engineer to call under
the terms of your guarantee. However, a
charge may be made if any of the following
applies to your machine:
● Is found to be in working order.
● Has not been installed in accordance
with the installation instructions.
● Has been used incorrectly.
ENGLISH
11