Trouble Shooting - Hoover TVX33 Reverse Action Gebrauchsanleitung

05651114.qxd 24-05-02

Trouble shooting

Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
● Have you selected the correct drying
time/program? Go to page 7.
● Were the clothes too wet? Were the
clothes thoroughly wrung or spin-dried?
● Does the filter need cleaning? Go to
page 6.
● Is the dryer overloaded? Go to page 5.
● Is the venting hose kinked or blocked?
Go to page 4.
● Is the load too small? Go to page 11.
● Has the 'HEAT SETTING' option been
selected from a previous cycle? Go to
page 8/10.
The dryer does not operate:
● Is there a working electricity supply to
the dryer? Check using another
appliance such as a table lamp.
● Is the plug properly connected to the
mains supply?
● Is there a power failure?
● Has the fuse blown?
● Is the door fully closed? Go to page 9/11.
● Is the dryer switched on, both at the
mains supply and at the machine? Go to
page 8/10.
● Has the drying time or the program been
selected? Go to page 8/10.
● On TVE43: Have you pressed the
'START' button to begin the program?
Go to page 11.
● On TVE43: Has the 'START DELAY'
option been set and is there still time
remaining? Go to page 11.
13:53 Page 13
● On TVX33: Has the 'ON' button been
● On TVE43: Has the 'START' button
Filter Care Indicator on
● Does the filter need cleaning? Go to
● Is the venting hose kinked or blocked?
Drum light does not operate
● The drum light can be replaced by
If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from Hoover
Service or an authorised Hoover Dealer.
Should there still be a problem with your
dryer after completing all the recommended
checks, please call Hoover Service for
advice. They may be able to assist you over
the telephone or arrange for a suitable
appointment for an engineer to call under
the terms of your guarantee. However, a
charge may be made if any of the following
applies to your machine:
● Is found to be in working order.
● Has not been installed in accordance
● Has been used incorrectly.
ENGLISH
pressed after opening the door? Go to
page 6.
been pressed after opening the door?
Go to page 6.
page 6.
Go to page 4.
unscrewing the glass cover and
unscrewing the bulb. The bulb should be
replaced by type E14 (10W, 240V).
with the installation instructions.
13