Troubleshooting; Environment Concerns; Declaration Of Conformity - Klarstein 10027129 Anschluss- Und Anwendungshinweise

Problem
The extractor fan ceases
to function.
Insuffi cient suction
power.
Hood has switched off
during operation.
The lamps do not light
up.
Oil leakage.
Hood shakes during
operation.
According to the European waste regulation 2002/96/EG this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. by ensuring this product is disposed of correctly,
you will help prevent potential negative consequences for the environment and hu-
man health, which could otherwiese be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
This produkt is conform to the followring European Directives:
2014/35/EU (Low voltage)
2014/30/EU (EMV)
2011/65/EG (RoHS)
2009/125/EG (ErP)
9

Troubleshooting

Possible cause
The kitchen hood feed cable
is not connected to the
network.
There is no electrical current
in the network.
Did not set to the right
speed and/or air outlet be-
ing blocked.
The safety cut-out device
has been tripped.
The lamps are burnt out.
The lamps are loose.
One-way valve and air ven-
tilation entrance not tightly
sealed.
Leakage from the connec-
tion of U-shaped section and
cover.
Leaf is damage.
The body or motor tightly
hung.

Environment Concerns

Declaration of Conformity

Solution
Connect feed cable to the network.
Check that the network has electrical current.
If the kitchen hood is set up for recirculation, check
that the charcoal fi lter is still eff ective.
If the kitchen hood is set up for extraction, check
that the ducting and outlets are not blocked.
The kitchen is adequately vented to allow the entry
of fresh air.
Turn off the hood and then wait for the device to
reset.
If the hood has been installed below the heights
indicated in the installation instructions, the mo-
tor will cut-out frequently which may damage the
hood.
Change the lamps.
Tighten the lamps.
Seal with glue on the one-way valve.
Seal with soap or paint on U-shaped section.
Replace the leaf as a damaged leaf causes shaking.
Lock the motor tightly or fi x the body tightly, res-
pectively.