Software Upgrade - SELFSAT SNIPE Air Bedienungsanleitung

4. Software Upgrade

NOTE
USB 2.0 standard has to be only used for upgrade
1. Transfer software program to a USB root folder (not belonging to any other folder) in an empty USB.
i. Please go to website www.selfsat.com to download update program (software).
ii. In case a controller does not recognize the USB drive, take the USB out and plug into a PC.
Right click USB folder, go to "Properties" and check if the "File system" is FAT32.
If not, right click USB folder again, go to "Format" and re-setup a file system to FAT32.
2. Ensure that the unit is turned off and plug the USB into USB port on the side of controller.
3. Press and hold TUNE button then also press the POWER button.
4. Unit will turn on and "USB connected, F/W Update mode" will be shown on LCD.
5. Once "UPGRADE FINISHED" is shown, update is completed, remove the USB device.
CONTROLLER
USB
ENGLISH - 11
Cigarette lighter adaptor or Power input cable