Safety Notes; Important Notes; Functions; Notes On Digital Operation - Trix H0 22245 Bedienungsanleitung

Safety Notes

• This locomotive is only to be used with the operating system it
is designed for.
• Analog max. 15 Volts DC, digital max. 22 volts AC.
• This locomotive must not be supplied with power simultane-
ously by more than one power source.
• Please make note of the safety notes in the instructions for
your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.

Important Notes

• The operating instructions and the packaging are a component
part of the product and must therefore be kept as well as
transferred along with the product to others.
• Maintenance, servicing, and repairs may only be done by adults.
• Please see your authorized Trix dealer for repairs or spare parts.
• The warranty card included with this product specifies the
warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• Built-in electronic circuit for operation with a conventional DC
power pack, Märklin Digital, Trix Systems or NMRA DCC digital
systems.
• Automatic system recognition between digital and analog
operation.
• Mfx technology for the Mobile Station 66950 / Central Station
60213/60214/60215.
Name set at the factory: RE 4/4 I 10036
• The full range of functions is only available under
Märklin Digital, Trix Systems and under DCC.
• Built-in headlights that change over with the direction of
travel. They can be turned on and off in digital operation.
• Minimum radius for operation is 360 mm / 14-3/16".

Notes on digital operation

• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
• The values set at the factory have been selected for mfx in
order to guarantee the best possible running characteristics.
Adjustments may have to be made for other operating
systems.
• The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block. If you
want this characteristic, you must do without conventional DC
power operation (CV 29/Bit 2 = 0).
9