Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Operation; Using The Scales - Silvercrest SPW 180 C3 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SPW 180 C3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 44

Initial operation

1) Open the battery compartment 2 by sliding
the cover in the direction of the arrow and then
removing it.
2) Insert the battery into the battery compart-
ment 2 according to its polarity.
3) Slide the cover back on to the battery compart-
ment 2 until it clicks into place.
4) Place the scales on a fl at, fi rm surface and tap
the centre of the scales with your foot to switch
it on.
5) Pick up the scales and set the desired unit of
measurement (kg, lb or st) by pressing the
UNIT button 1 on the rear of the scales
NOTE
The unit of measurement must only be set on
fi rst use.
6) Place the scales on a fl at and stable surface.
Ensure that neither the fl oor at the location of
the scales nor the upper surface of the scales
are wet, otherwise there is a risk of slipping!
NOTE
These scales contain sensitive electronic
components and should therefore NOT be
located:
close to sources of heat
in environments with extreme air humidity.
The scales are now ready for use.
SPW 180 C3

Using the scales

WARNING! RISK OF INJURY!
Never use the scales if they are wet
or moist. Never step onto the scales
with wet or moist feet. There would
be a serious risk of slipping and
personal injury!
Never put weight onto only one
side of the scales. Always step onto
the scales in the middle and with
both feet. Otherwise, the scales
could tip and become irreparably
damaged. There is also a risk of
falling over!
ATTENTION! DAMAGE TO PROPERTY!
Never jump onto glass scales! This could
irreparably damage them.
1) Tap your foot on the middle of the scales to
switch them on.
2) Stand with both feet on the scales. Stand as
still as possible and without displacing your
weight.
3) During the weighing process, the indicated
weight increases until your weight is shown.
4) Once your weight has been determined, the
result blinks three times on the display 3.
NOTE
If the display 3 switches off during weighing,
the scales cannot measure the weight correctly.
In this case, step down from the scales, wait
a few seconds and then try again. Make sure
you stand still and do not interrupt the weighing
procedure.
GB
CY
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis