Beninca CP.BISON OTI Bedienungsanleitung Seite 18

RESET of the control unit. WARNING: Returns the control unit to the default values.
When the <PG> push-button is pressed once, the RES wording begins to flash, if the push-button<PG> is pressed once more, the
control unit is reset.
Note: neither the transmitter codes nor the position and stroked of the gate leaf will be erased from the receiver.
The automatic system stroke is self learned. See section "STROKE SELF-LEARNING"
It allows to type in an access protection code to the programming of the control unit.
A four-character alphanumeric code can be typed in by using the numbers from 0 to 9 and the letters A-B-C-D-E-F.
The default value is 0000 (four zeros) and shows the absence of a protection code.
While typing in the code, this operation can be cancelled at any moment by pressing keys + and – simultaneously. Once the password
is typed in, it is possible to act on the control unit by entering and exiting the programming mode for around 10 minutes in order to
allow adjustments and tests on functions.
By replacing the 0000 code with any other code, the protection of the control unit is enabled, thus preventing the access to any other
menu. If a protection code is to be typed in, proceed as follows:
- select the Code menu and press OK.
- the code 0000 is shown, also in the case a protection code has been previously typed in.
- the value of the flashing character can be changed with keys + and -.
- press OK to confirm the flashing character, then confirm the following one.
- after typing in the 4 characters, a confirmation message "CONF" appears.
- after a few seconds, the code 0000 appears again
- the previously stored protection code must be reconfirmed in order to avoid any accidental typing in.
If the code corresponds to the previous one, a confirmation message "OK" appears.
The control unit automatically exits the programming phase. To gain access to the Menus again, the stored protection code must be
typed in.
ImPORTANT: TAKE NOTE of the protection code and KEEP IT IN A SAFE PLACE for future maintenance operations.
To remove the code from a protected control unit, enter the programming mode with the password and reset the
code to the 0000 default value.
IF YOU LOOSE THE CODE, PLEASE CONTACT THE AUTHORISED SERVICE CENTER FOR THE TOTAL RESET OF
THE CONTROL UNIT.
TABLE 1
FSTS Speed
Value (m/min)
30 7
35 8
39 9
44 (DEFAULT) 10
48 11
53 12
57 13
18
RESET (RES)
AUTOSET (AUTO)
PASSWORD (CODE)
Leaf max. weight Leaf max. weight
BISON 20 (kg) BISON 40 (kg)
2500 4000
2500 4000
2500 4000
2500 4000
2000 3200
1700 2700
1450 2300
FSTS Speed Leaf max. weight
Value (m/min) BISON 20 (kg)
62 14
67 15
71 16
76 17
80 18
85 19
89 20
Leaf max. weight
BISON 40 (kg)
1250 2000
1100 1750
950 1500
850 1350
750 1200
650 1000
600 950