5.12.3 TAIL LAMP (WITH STOP LIGHT)
Parking light + stop light
•
Bulb 2V ‑ 2/5W (P2/5W)
2
Note: visually check if the stop light works properly,
3
by pulling one of the two brake levers.
4
Replacing tail lamp light bulb
•
Remove the cover by loosening the 2 screws
5
(C‑Fig.29).
•
Replace light bulb (L‑Fig.29).
•
Fasten the cover.
6
ENG
C
42
L
Fig.29
5.12.4 REAR TURN INDICATOR
Rear turn indicator
•
Bulb 2V ‑ 0W (W0W)
Replacing rear turn indicator light bulb
•
Remove the transparent cover by loosening the
relative screw (C‑Fig.30) (right or left, depending on
which bulb you need to replace).
Replace light bulb (L‑Fig.30).
•
•
Fasten the cover.
The rate at which the turn indicator warning light
on the instrument board flashes will increase
to signal that one of the four indicators is not
working.
C
L
Fig.30