Troubleshooting - AEG LB3690WT Benutzerinformation

1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.

15. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
15.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly.
• - The appliance does not drain
the water.
15.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
•
•
•
•
Possible solution
Make sure that the mains plug is connected to the mains sock-
et.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end of
countdown.
Deactivate the Child Lock function if it is on.
Make sure that the water tap is open.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH 29