Battery Installation & Replacement - Refco REF-METER Bedienungsanleitung

REF-METER User's Guide
Unpacking the REF-METER
1. Remove the REF-METER from the carry case.
2. Remove the control box from the storage dock in right side of the weighing
platform by pulling the control box firmly from the dock.
3. Unwrap the coiled cord from around the weighing platform. When using the REF-
METER, ensure the coiled cord does not touch the top of the weighing platform,
or inaccuracies may result.
4. If desired, extend the easel at the top back of the control box by pulling it out.
The easel may be used straight for hanging, or folded at an angle for resting on
a level surface.
Repacking the REF-METER
1. If extended, restore the easel to the retracted position.
2. Wrap the coiled cord counter-clockwise around the weighing platform.
3. Push the control box firmly into the storage dock of the weighing platform until it
snaps in place.
4. Replace the REF-METER into the carry case.
Battery Installation & Replacement
1. Remove the battery cover from the rear of the control box by compressing tab at
the base of the battery cover.
2. If necessary, remove old set of batteries.
3. Insert 4 'AAA'. Replace battery cover by aligning tabs and snapping back into
place.
IMPORTANT: TO PREVENT DAMAGE TO THE REF-METER, CAREFULLY
OBSERVE BATTERY POLARITY AS MARKED INSIDE THE BATTERY
COMPARTMENT. DO NOT LEAVE DEAD BATTERIES INSIDE THE CONTROL
BOX. REMOVE BATTERIES IF THE REF-METER IS NOT TO BE USED FOR AN
EXTENDED PERIOD OF TIME.
6
English