Refco REF-METER Bedienungsanleitung Seite 15

English
Restoring Factory Calibration
If you make a mistake recalibrating the REF-METER, you can always restore the
factory calibration (and factory defaults) of the scale.
To restore the factory settings perform the following steps:
1. Turn the power to the REF-METER off.
2. Remove any objects from the platform.
3. While holding
beep 10 times. The factory settings are now restored.
4. Refer to the Quick Start section above for setting the desired Units and
Resolution.
Sound
As delivered from the factory, the REF-METER beeps when turning on and when
keys are pressed. This sound can be muted as follows:
1. Make sure the power is on.
2. While holding
will turn off to indicate that the sound has been muted.
Repeat steps 1 and 2 to turn the sound back on.
NOTE: The Mute function only affects the power-on and key-press beeps. It has no
effect on the alarm.
, press and release
, press . The musical symbol on the left of the display
REF-METER User's Guide
. The REF-METER will turn on and
13