Refco REF-METER Bedienungsanleitung Seite 11

English
4. Press and/or hold the
change the set point faster, press
which will change the set point 10x faster than normal. Press
to the normal speed SET mode.
5. Press . The display will automatically change to zero and the RUN indicator
will show to indicate that the program is running.
6. When the applied (or removed) weight exceeds the programmed amount, the
alarm will sound and the DONE indicator will flash on the display.
7. Press any key to stop the alarm.
8. To cancel the RUN mode at any time, press the
NOTE: The RUN mode can only be initiated from the SET mode. If you cancel the
RUN mode by pressing
point will be restored) followed by
program restarts. You may program the SET mode without starting the RUN mode
by pressing after setting the program set point. The new value will be saved
until next time the SET mode is activated.
similarly as described in the HOLD MODE section. The REF-METER-PLUS
provides additional functionality when using the RUN mode. Refer to the REF-
METER-PLUS User's Guide for details.
Tank Capacity Mode
It is o ften convenient to know the relative amount of material (i.e. refrigerant)
remaining in a container (tank). The REF-METER's Tank Capacity Mode allows a
continuous display of the percentage of material remaining in a tank. In order to
compute the percentage accurately, the REF-METER must be trained to know the
weights of an empty and full tank. To train the REF-METER Tank Capacity Mode,
perform the following steps:
or keys to set the desired alarm set point. Ref To
. This will activate the FAST SET mode
, and wish to RUN again, press
again. The display will be zeroed when the
REF-METER User's Guide
key.
can be used during the RUN mode
again to return
(the previous set
9