Wolf GKS-Eurotwin-K 450 Montage- Und Bedienungsanleitung Seite 30

DIN 3440: The controllers and limiters allocated to
the boilers must comply with DIN 3440 (in future:
DIN EN 14597).
DIN 4753: DHW heating systems for drinking and
process water.
DIN 4755: Oil combustion systems - technical rules for
oil combustion installations (TRÖ) - inspection.
DIN 4787-1: Vaporising oil burner; terms, safety
requirements; testing, identification.
DIN 4788, part 1: Atmospheric gas burner.
DIN 4795: Draught stabiliser for domestic chimneys;
terms, safety requirements, testing, identification.
DIN 51603, part 1: Fuel oil, fuel oil EL, minimum
requirements.
DIN 18160-1: Flue gas systems - part 1: Designing and
implementation.
DIN EN 230: Burner control units for oil burners.
DIN EN 267: Pressurised oil burners - terms,
requirements, testing, identification.
DIN EN 298: Burner control units for gas burners and
pressurised or atmospheric gas fired appliances.
DIN EN 676: Automatic pressure-jet burners for gaseous
fuels.
DIN EN 12828: Heating systems in buildings - designing
hot water heating systems.
DIN EN 12831: Heating systems in buildings - procedure
for calculating the standard heating load.
DIN EN 12953-6: Boilers with large water chamber:
Requirements for the boiler equipment.
DIN EN 13384-1: Flue gas systems - heat and flow rate
calculations.
DIN EN 14597: Temperature control and limiting
facilities
30
Technical rules
DVGW-TRGI 1986, issued 1996: Technical rules for
gas installations.
DVGW Code of Practice G 260/l: Gas quality.
DVGW W 551: DHW heating systems
- Technical measures to reduce the growth of legionella
bacteria.
TRF 1996: Technical rules for LPG.
ATV-A-251 Materials for drain pipes for condensate from
condensing boilers.
VDI 2035 sheet 1-3: According to VDI 2035, the heating
water for systems = 100 °C or to VdTÜV 1466 for systems
= 120 °C must be treated.
VDI 2050: Observe technical principles for design and
implementation for heating centres in buildings, as well
as approval, permit and acceptance procedures, as
described in the respectively applicable form.
VDE regulations / technical connection conditions: The
installation of the gas supply must be carried out in
accordance with the technical connection conditions of
the gas supply utility, and the installation of the electricity
supply in accordance with the VDE regulations and the
technical connection conditions of the power supply
utility. Operate the system in accordance with the above
conditions.
VDE 0116: Electrical equipment of combustion
systems.
FeuVo: Combustion Order, State Order [Germany].
Boilers may only be installed and operated in boiler
rooms that are suitable according to the Landes-FeuVo
[or local regulations].
HeizAnlV; heating system regulations
Keep the enclosed operating instructions in a clearly
visible position in the boiler/installation room. Insert all
further documentation in a clear wallet and clip it into
the boiler side casing.
Your boiler and burner should be maintained and
cleaned on an annual basis by a heating contractor,
to ensure the reliable and economic function of your
heating system.
We would recommend a maintenance contract.
3062011_0511